Exam 12: Steering Diagnosis and Service

The height of the center of gravity is determined by the ______ of the center of the mass above the road surface.

The first step in removing and replacing the power steering pump is to:

________ is when the rear slip angle is larger than the front slip angle; it is referred to as the vehicle being "loose" in the corners.

Tech A states that when diagnosing a steering system problem it is important to consider just the mechanical components at first. Tech B states that when diagnosing a steering system problem it is important to consider both the mechanical and electrical components, and that a factory scan tool is very helpful in this process. Who is correct?

A _________ is recommended by most manufacturers because it can perform tests and identify faults with the electrical portion of steering systems.

The tire's sideways distortion makes the vehicle follow a path at an angle to the direction the road wheel is pointing in what is called the ________.

The static weight distribution is changed laterally by ________ when the vehicle is turning and in a fore-and-aft direction during acceleration or braking.

The power steering system pressure test checks the operation of the _________, power piston, and hoses.

The goal for the _______ adjustment is to remove play at the worm bearings while maintaining a low resistance to worm shaft movement.

The _____ is a flexible ribbon that is coiled inside of a plastic holder.

Tools and equipment used on the mechanical portion of the steering system include all of the following EXCEPT:

Technician A says flushing the power steering system is to occur whenever the manufacturer specifies a fluid change or whenever the fluid appears to be contaminated or dirty. Technician B says flushing the power steering system is to occur whenever the power steering belt is replaced. Who is correct?

Typically, a power steering system flush is performed with a _______ that is connected in line with the power steering system pump to remove all old dirty fluid and install new clean fluid without introducing air.

Which statement is correct?

Identify the tool that is used to make adjustments to the steering system.

The height of the vehicle center of gravity is determined by the _______ of the center of mass above the road surface.

The ________ protect(s) the inner tie-rod ends from dirt and contaminants.

Dispose of discarded fluid properly in accordance with the relevant ______ and government legislation.

The first step to perform a power steering system flush is to:

A(n) _________ is used to measure voltage and to check the continuity of the electronic circuit.