Exam 6: Network Hardware

MATCHING Match each item with a statement below: a.PCIe f.switch b.FireWire g.cut-through mode c.CardBus h.store-and-forward mode d.repeater i.loopback adapter e.bridge -External peripheral device specifying 32-bit interface running at 33 MHz.

A(n)____ is the circuit board wire over which a device issues voltage to signal this request.

By far,the most popular expansion board NIC is one that uses a(n)____ bus.

A router that directs data between nodes on an autonomous LAN (or one owned and operated by a single organization)is known as a(n)____________________ router.

MATCHING Match each item with a statement below: a.PCIe f.switch b.FireWire g.cut-through mode c.CardBus h.store-and-forward mode d.repeater i.loopback adapter e.bridge -Connectivity device that subdivides a network into smaller logical pieces.

____ are combinations of networking hardware and software that connect two dissimilar kinds of networks.

The primary difference between the two USB standards is ____.

Each time a computer starts up,the device drivers for all its connected peripherals are loaded into ____.

If the ____ NIC LED indicator is blinking,the NIC is functioning and receiving frames.

A ____ is a repeater with more than one output port.