Exam 7: Introduction to Router Configuration

The router commands used to configure and enable the FastEthernet 0/1 router interface with the IP address of 10.10.20.250 and a subnet mask of 255.255.0.0 are: Router# conf t Router(config)# int fa0/1 Router(config-if)# ip address 10.10.20.250 255.255.0.0 Router(config-if)# no shut

_________ is (are)the name(s)for more advanced switch security.

The designation s0/0 indicates which of the following?

The AUI port on a router connects to which networking protocol?

The DCE end of a V.35 cable is female.

AUI stands for which of the following?

Switches typically operate within which OSI level?

Why is it recommended as a best practice to change the name of the default VLAN 1?

The values for configuring a serial connection to connect to a Cisco router's console port are: 5600bps 8 data bits No parity 1 stop bit Hardware flow control

The prompt for a router's user EXEC mode is router/ >.

On STP-enabled switches,which of the four STP states can be bypassed to speed up the process?

What switch information is not available with the show version command?

Which of the following is not an action that can be taken in the event of a port violation?

The command line vty 0 4 means: line places the router in the line configuration mode vty: virtual terminal 0 4: indicates virtual terminal connections can be simultaneously configured

Which of the following is a recommended switch security best practice?

The sh ip int brief command shows that the protocol for Ethernet0 is "down" and the status is up.This indicates which of the following?

The sequence of commands for setting the enable secret to Chile is: router> enable router# enable secret Chile

A switch needs to communicate with an authentication server for which feature to function?