Exam 13: Wheel Alignment Principles
Exam 1: Strategy-Based Diagnostics40 Questions
Exam 2: Safety40 Questions
Exam 3: Basic Tools and Precision Measuring40 Questions
Exam 4: Fasteners and Thread Repair40 Questions
Exam 5: Wheels and Tires40 Questions
Exam 6: Tire Pressure Monitoring Systems40 Questions
Exam 7: Tire and Wheel Diagnosis and Service40 Questions
Exam 8: Wheel Bearing and Seal Service40 Questions
Exam 9: Suspension Systems40 Questions
Exam 10: Suspension System Service40 Questions
Exam 11: Steering Systems40 Questions
Exam 12: Steering Diagnosis and Service40 Questions
Exam 13: Wheel Alignment Principles40 Questions
Exam 14: Drive Axle Shafts and Cv Joints40 Questions
Exam 15: Wheel Alignment Adjustments40 Questions
Select questions type
If the camber line is ________ of the SAI line, then it has positive offset or positive scrub radius.
(Multiple Choice)
4.8/5
(38)
The ________ needs to be centered at the completion of a wheel alignment
(Multiple Choice)
4.8/5
(27)
Tech A says you can adjust caster on some strut rods. Tech B says you can adjust caster on some four-wheel-drive vehicles with adjusting sleeve. Who is correct?
(Multiple Choice)
4.8/5
(34)
Not all vehicles have adjustable _______, so in some cases, only toe can be set, unless aftermarket components are installed that allow for adjustment.
(Multiple Choice)
4.8/5
(34)
Technician A says camber is the side-to-side vertical tilt of the wheel when viewed from the front of the vehicle and is measured in degrees. Technician B says that a wheel that leans away from the center of the vehicle at the top is said to have negative camber. Who is correct?
(Multiple Choice)
5.0/5
(39)
Tech A says that thrust angle refers to the direction the front wheels are pointing. Tech B says that scrub radius refers to the vertical centerline of the tire in relation to an imaginary line through the steering knuckle pivots. Who is correct?
(Multiple Choice)
4.8/5
(41)
Tech A says that the front wheels should be aligned before the rear wheels. Tech B says that front wheel toe should be adjusted after front wheel camber and caster. Who is correct?
(Multiple Choice)
4.9/5
(37)
_______ is the forward or backward tilt of the steering axis from vertical when viewed from the side of the vehicle.
(Multiple Choice)
4.9/5
(32)
Tech A says setback is not adjustable. Tech B says setback can cause a pull on a front-wheel-drive car. Who is correct?
(Multiple Choice)
4.9/5
(48)
The ________ is slightly egg shaped or has a slightly egg-shaped washer attached to one side of the bolt.
(Multiple Choice)
4.8/5
(45)
_______ is the side-to-side vertical tilt of the vehicle's wheels.
(Multiple Choice)
4.9/5
(39)
The condition in which the fronts of the wheels are farther apart than the rears is called ________.
(Multiple Choice)
4.9/5
(38)
Tech A says that incorrect toe settings will cause feathered wear across the tire tread. Tech B says that underinflated tires have more wear in the center of the tread. Who is correct?
(Multiple Choice)
4.9/5
(23)
During a vehicle alignment, shim adjustment can affect both ________ and ________.
(Multiple Choice)
4.8/5
(43)
Showing 21 - 40 of 40
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)