Exam 18: Transmission Reassembly

Where should compressed air should be used to ensure each fluid passage is clear and unobstructed?

What problems may occur if you fail to torque parts correctly when reassembling an automatic transmission?

Which of the following should you inspect each bushing inside an automatic transmission for?

When may it be necessary to purchase a complete bushing replacement kit and replace every bushing inside the transmission?

Technician A says that painting a rebuilt transmission helps to identify it as being a rebuilt transmission. Technician B says that painting a rebuilt transmission prevents the housing from leaking due to case porosity. Who is correct?

Technician A says preload refers to the amount of force placed on a bearing before any load is on the bearing. Technician B says free play refers to the distance that a bearing is able to turn before locking up. Who is correct?

When reinstalling _________ in an automatic transmission, apply a small amount of transmission assembly lube to hold them in place.

Which of the following bushings is most likely to be worn and need replacement during a transmission repair or overhaul?

Which of the following should you inspect each bushing inside an automatic transmission for?

Tech A states that an end play measurement that is too small can mean that you have excessive clearance in the clutch packs. Tech B states that an end play measurement that is too large means that the thrust washers are too big. Who is correct?

When installing manual shaft seals:

Which of the following can be worn by metal check balls?

All of the following statements with respect to case preparation are true except:

Automatic transmission parts may require lots of wiggling and turning when you are attempting to reassemble the transmission, but if you try to force them together, you will succeed only in damaging the parts.

If thrust bearings or washers are worn, ______ movement of components inside the automatic transmission will be allowed, affecting their operation.

When rebuilding an automatic transmission, check valves and/or check balls should be inspected for wear and damage.

Tech A says that if you are familiar with a transmission it is not necessary to check for updates before assembling the transmission. Tech B says that you should always check for revised specifications and/or service updates before assembling the transmission. Who is correct?

When reinstalling thrust bearings or washers in a transmission, apply a small amount of ______ to help hold it in place.

When may it be necessary to purchase a complete bushing replacement kit and replace every bushing inside the transmission?

When installing valve body bolts: