Exam 9: Engine Housing Components

If a single slab cylinder head is used on an in-line 6-cylinder diesel engine, how many engine cylinders will the cylinder head cover?

Which of the following liner types would likely be composed of the least amount of material?

When a hone is used to glaze-bust a liner what is the recommended grit stone rating?

When a cylinder head bolt torque specification requires that the fastener is first torqued, then turned through a further set number of degrees, the method is known as:

What would be a typical clearance specification for a "loose" fit dry liner?

Technician A says that cylinder block torque twist can be the result of high cylinder pressures. Technician B says that cylinder block toque twist can be the result of drivetrain forces outside of the engine. Who is correct?

What should be used to check valve seating?

Which of the following is NOT usually found in heavy-duty diesel engines?

Where does cavitation erosion normally occur on a wet liner?

Which of the following components would NOT be classified as part of the engine housing?

What is wet liner cavitation caused by?

What material is most commonly used in the manufacturing of diesel engine cylinder heads?

To what depth should a liner crosshatch be machined to?

In a heavy-duty diesel engine, which of the following is more likely to be described as tuned?

When following a cylinder head bolt torque sequence while torquing a single slab cylinder head, which bolts should be torqued last in the sequence?

When checking a cylinder block deck for warpage with a thickness gauge and straight edge, what would be a typical maximum specification?

What is the recommended crosshatch crossover angle on a typical liner?

Which of the following would be the preferred method of removing a tough-to-remove gasket from an oil pan flange?

What should be done before removing a piston from a liner?

Technician A says that a disadvantage of an induction-hardened parent bore cylinder block is that when a single bore wears, the cylinder block has to be replaced. Technician B says that cavitation erosion is more likely to occur in engines manufactured with parent bores. Who is correct?