Chat with AIExam 10: Cylinder Block: Inspection and Service
Exam 1: Engine Operation42 Questions
Exam 2: Engine Shop Safety70 Questions
Exam 3: Diagnosing Engine Problems45 Questions
Exam 4: Engine Removal, Disassembly, Inspection, and In-Chassis Repairs45 Questions
Exam 5: Cleaning the Engine40 Questions
Exam 6: Micrometer Practice35 Questions
Exam 7: Cylinder Head: Parts and Service45 Questions
Exam 8: Cylinder Head: Springs, Valves, and Valve Sets45 Questions
Exam 9: Camshafts, Lifters, Timing Belts, and Chains45 Questions
Exam 10: Cylinder Block: Inspection and Service44 Questions
Exam 11: Crankshaft, Bearings, and Engine Balancing45 Questions
Exam 12: Pistons, Rings, and Connecting Rods45 Questions
Exam 13: Lubrication45 Questions
Exam 14: Cooling System45 Questions
Exam 15: Engine Hardware: Fasteners, Thread Repair, and Gaskets45 Questions
Exam 16: Reassembly and Starting45 Questions
Exam 17: Engine Breathing: Intake and Exhaust Systems45 Questions
Exam 18: Turbochargers and Superchargers45 Questions
Exam 19: Producing Power: Valve Timing, Power and Torque Measurement45 Questions
Select questions type
Technician A says when glaze breaking a cylinder, you must go from the very top to the very bottom of the cylinder to achieve desired results. Technician B says a drill motor with a speed of 450 rpm works well for deglazing a cylinder. Who is correct?
(Multiple Choice)
4.8/5 
(44)
(44) Technician A says that if the camshaft is too tight after new cam bearings are installed, the bearing can be sanded with emery cloth. Technician B says that the front cam bearing is always installed flush with the front of the block. Who is right?
(Multiple Choice)
4.7/5 (46)
(46) What is the name for the 20° to 60° crisscross pattern left during cylinder wall honing?
(Short Answer)
4.8/5 (37)
(37) All of the following are used for chamfering a cylinder EXCEPT a _____.
(Multiple Choice)
4.7/5 (34)
(34) 
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)