Exam 7: Faucets and Drain Assemblies

A tub faucet is mounted on either the ____________________ or ____________________.

Lavatory faucet connections use which of the following connections.

All faucets are compatible with all sink designs.

____________________ faucets are installed for large-capacity tubs,such as a garden (roman)tub or whirlpool.

A single-handle lavatory faucet blends the hot and cold water with the use of one handle,and the spout is located directly below the handle.

A ____ is a drain assembly for lavatory sinks and bidets and is abbreviated as PO.

The most common type of kitchen faucet requires a sink that has three faucet holes that are _____" apart,or _____" from the hot and cold water supply connections to the faucet.

_______________ refers to items that have chrome or other finishes.

A typical sink faucet is either a __________- or __________-handle design

An ____________________ is a flange installed around a pipe to conceal pipe penetrations through a wall,floor,or ceiling.

Many bidets require a backflow prevention device to be installed.

_______________ is the color or polish of a faucet,drain assembly or other fixture trim item.

Most codes dictate that a vacuum breaker must be installed when a handheld shower is installed if the handheld could be submerged in water.

Most pull-out spout kitchen sink faucets are not manufactured with an integral check valve to eliminate backflow.

The two-handle lavatory faucet design requires a user to operate both handles to achieve a desired temperature.

Many faucet manufacturers offer unique designs that allow a spray unit to be installed without having to install a four-hole sink by having the spray unit manufactured in the faucet ____________________.

A ____ is a removable threaded housing for a screen attached to a faucet spout,which creates a uniform flow stream.

Many popular kitchen sink faucet designs have a pull-out spout that is also the spray unit,but this does not eliminate ordering a four-hole sink.

The most common lavatory designs have a _____" spread between the hot and cold handles.

A ____ is an opening in a fixture,such as a drain or overflow hole that receives drain assemblies,to connect the fixture to the drain system.