Exam 15: Fixture and Equipment Installation

A plumber usually installs a dishwasher.

A ____________________ is installed to connect the stub-out pipe to the p-trap outlet.

MATCHING Match the following terms: -Floor or wall plate installed around a stub-out pipe to conceal the penetration.

A two-piece toilet is assembled by a plumber on a job site.

Testing fixture installations is performed with a performance test and a pressure test.

MATCHING Match the following terms: -Also called a toilet flange;installed to connect a toilet to the drainage system.

MATCHING Match the following terms: -A type of connection used for water distribution tubing.

MATCHING Match the following terms: -A slip joint-style fitting installed to connect a tubular p-trap to the drainage system.

A kitchen faucet is typically installed after installing a new kitchen sink.

A ____________________ has a designated port to connect the dishwasher drain hose.

MATCHING Match the following terms: -A pipe size that is smaller in diameter and has a thinner wall thickness than pipe used for drainage piping.

Some codes require a dishwasher drain hose to be routed through an air gap device.

A toilet is installed onto a _______________ flange with a _______________ seal and a set of _______________ bolts.

Most fixture installations occur during the rough-in phase of construction.

Turning a metal escutcheon in the opposite direction and installing it temporarily over the pipe will bend the tabs inward and enable an easier fit around the stub-out pipe.

The water connection to a toilet requires a specific supply tube known as a ____________________.

MATCHING Match the following terms: -A drain assembly used to connect a double-bowl kitchen sink to a single p-trap.

A _______________ is installed on all sinks and connects the fixture outlet to the rough-in stub-out pipe.

MATCHING Match the following terms: -Non-corrosive bolts inserted into a closet flange to anchor the toilet to the drainage system.

When installing a stop that is soldered onto copper,the ____________________ and ____________________ is typically removed so the rubber washer is not damaged.