Exam 56: Engine Installation, Break In, and In-Chassis Repairs

When it is not possible to prime the system by removing the distributor, either use a(n) ____________________ or remove all spark plugs and crank the engine.

Older engines with carburetors were susceptible to ____________________ that occurs when fuel vaporizes in a line and a bubble blocks fuel flow.

Engine mount bolts should be used to pull a V-type engine into place.

A faulty ____ often points to a need for head surfacing, cooling system service, or repair to the engine's fuel or ignition system.

How would you remove the timing cover?

What precautions should you bear in mind when taking a test drive?

While having a discussion, Technician A says that to avoid vapor lock, be sure that all fuel lines are positioned at least 1/2" from any heat source. Technician B says that fuel filters should be positioned where they can be cooled by air. Who is correct?

Do not open the radiator cap unless the hose collapses when squeezed.

While having a discussion, Technician A says that if the timing is retarded, engine idle will be too high. Technician B says that if the timing is advanced, the idle will be too low. Who is correct?

Briefly discuss the technique that you would use to help seat the piston rings.

If the oil pan is to be removed with the car on a lift, the tool that is MOST-Likely used to raise the car is a(n):

All of the following statements are true EXCEPT:

Some ____________________ sensors can be triggered by a rattle from a loose valve adjustment or a muffler vibrating against the frame.

Which of the following statements is LEAST-Likely true?

All of the following statements are true EXCEPT:

An engine that has enough piston-to-valve clearance to prevent contact is MOST-Likely known as a(n):

What items should be checked when running an engine for the first time?

Engine-to-transmission housing screws provide alignment.

How would you adjust the hydraulic lifter lash with the engine idling?

Oil consumption might not stabilize until all parts have seated to one another. The customer should not be concerned until the vehicle has been driven at least ____ miles.