Chat with AIExam 6: Router Startup and Configuration
____ mode is actually the bootstrap program that is built into the firmware of the router.
(36) 
VerifiedB
What are the options of the show cdp neighbors command?
(43) VerifiedThe show cdp neighbors command supports the following options:
• FastEthernet -To learn more about FastEthernet interfaces attached to neighbors
• Serial -More information about neighbors connected to serial interfaces
• Detail -Detailed information about the CDP neighbor and all attached devices. This detailed information includes device identification, remote interface type, and remote IP address.
Describe the Security Device Manager (SDM).
(31) VerifiedSDM is a Web-based tool primarily used for implementing and testing security configurations; it is also available as a free download. SDM can be used with many router models and a wide range of IOS releases. It is most commonly used to configure routing protocols, WAN services, wireless routing, firewalls, virtual private networks (VPNs), and quality of service (QoS). Most of these more advanced concepts will be addressed in later chapters. It is important to note that SDM is typically not used to configure basic functionality on a Cisco router and, in fact, SDM cannot do all things. However, SDM does help with the most complex configuration commands and it allows testing of the configuration. If there is a problem, SDM will even help troubleshoot it for you. In short, SDM makes it easier for network administrators to implement complex configurations requiring many commands much more easily and without the CLI knowledge that was necessary in the past. You can practice with SDM even without a router connected by downloading the demo.
If you want to view the contents of the startup-config, you can type ____ at the enable prompt.
(33) The boot system flash ____ command will force the router to boot into ROM.
(32) If you want to perform general IP packet debugging, type the following:
(27) Verified (33) Using the ping command alone is referred to as ____________________.
(34) Trace use ____ messages to verify that the destination host is reachable, and if not, give possible reasons for the problem.
(34) If you want to disable CDP information from being sent on a given interface, change to the interface configuration mode prompt, and then issue the ____ command.
(33) Sometimes the ____ file is referred to as the backup configuration because it is the saved version of the configuration file.
(37) If you accidentally initiate a connection with another router from your locally attached router, you can stop the process by pressing ____.
(31) Most types of computer equipment perform some type of POST immediately after being turned on.
(25) ROM in the router contains a limited version of the IOS. When accessing this limited IOS version, you are in ____ mode.
(46) The command ____ copies the configuration from the TFTP server to the startup configuration.
(37) If you want to see your working or running configuration, type ____ at the enable prompt.
(35) 
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)