Exam 6: Router Startup and Configuration

A(n) ____ server is a computer, such as a PC, UNIX workstation, or laptop that is running TFTP server services.

What are the basic steps to implement changes in a router?

You can use the ____ command in enable mode to retrieve the statistics that CDP will report on the local router's interfaces.

You can add the word ____ to an ip address command and configure the address as a second IP address for the interface.

During a POST, the bootstrap program, also called the ____________________, checks basic operations of the attached hardware, including CPU, memory, and interfaces.

Briefly describe IP route on a Cisco router.

What are the replies return by a trace?

In the event you are configuring a serial interface as a DCE (data communication equipment), you will need to add the ____ [bandwidth in bits per second] command.

All Cisco devices, including routers, switches, and wireless access points, can use ____ to discover each other and learn about the configurations of other devices.

Using CDP can help you quickly determine the network topology.

In a Cisco router, if the interfaces are down, packets can still be received or delivered.

You can examine the configuration register by typing ____ at either the enable mode or user mode prompt.

The ROM Monitor checks the _________________________ for instructions regarding how to load the Cisco IOS.

If you want to add an entry to your hosts file for name resolution, you must go to ____________________ configuration mode.

Briefly describe the Cisco configuration register.

____ in a router typically contains the power-on self-test (POST).

Ping and Trace are available only from the user EXEC mode.

To manually configure IP on an interface, you must first change to interface configuration mode. Then, you can use the ____ command to configure an IP address for the specific interface.

Trace sends multiple ICMP packets with progressively higher ______________________________ until the packet reaches the destination.

The command ____ indicates that you want to overwrite the existing NVRAM with the configuration information stored on the TFTP server.