Exam 3: Basic Tools and Precision Measuring

In four-wheel drive applications, which of the following components transfers the drive from the transfer case (torque splitter) to the final drive units at the front and rear axle assemblies?

In manual transmission, which of these determines the path of the power flow from the countershaft to the output shaft?

Gear pullers come in a range of sizes and shapes, all designed for particular applications.

Larger diameter rivets should be used for jobs that require less strength.

The ________ is used to apply a specified amount of torque to a fastener.

The most common types of micrometers are:

A screw or bolt with a cross-shaped recess requires a(n) __________ or a Pozidriv screwdriver.

Torque wrenches come in all the following types, EXCEPT:

A(n) _________ can be moved on the bed until the precise drilling point is located and then tightened down by bolts to hold it in place during drilling.

When measuring spark plug gap, feeler gauges should not be used because the surfaces of the spark plug electrodes are not perfectly _____, so it is preferable to use wire feeler gauges.

The blades of a gasket scraper come in different sizes, with a typical size being ____ wide.

Technician A says a dial indicator may also be known as a dial gauge. Technican B says dial indicators have a dial and needle where measurements are read. Who is correct?

Which of the following is a variation on the open-end wrench?

Technician A states that a power tool can be stationary, such as a bench grinder, or portable, such as a portable electric drill. Technician B states that power tools make many tasks quicker and easier to perform, and they can save many hours of work when used and maintained correctly. Who is correct?

There are two types of rear axle assemblies used in modern vehicles: the solid rear axle and the independent rear axle.

Technician A says that a dead blow hammer reduces rebound of the hammer. Technician B says that a dead blow hammer should be used to cut the head of a bolt off with a chisel. Who is correct?

A ________ is designed not to bounce back when it hits something.

Technician A says a typical outside micrometer has an anvil and spindle. Technician B says a typical outside micrometer has a barrel and ratchet. Who is correct?

Technician A states that tools are typically located in each corner of the workshop. Technician B states that tools are usually located in a centralized location. Who is correct?

Tech A says that when using a file, apply pressure to file in the direction of the cut and no pressure when pulling the file back. Tech B says that file cards are used to file uneven surfaces. Who is correct?