Exam 11: Ppp and Frame Relay

____ checks the reliability of the link by monitoring the number of errors, latency between requests, connection retries, and connection failures on the PPP link.

Frame Relay separates each data stream into logical (software-maintained) connections called ____.

Using authentication with PPP connections is mandatory.

____ is a communications technique for sending data over high-speed digital connections operating at anywhere from 56 Kbps to 44.736 Mbps or higher.

Compared with PAP, CHAP provides a much more simple authentication process.

Frame Relay connections identify virtual circuits by ___________________________________ numbers.

The ____ is the most expensive Frame Relay topology to implement because each router has a direct connection to every other router.

Asynchronous serial connections are typically used with analog modems.

What are the performance parameters for a Frame Relay connection?

Explain the use of DLCI numbers in Frame Relay.

PPP is an Internet standard protocol defined in RFCs 2153 and ____.

The basic LMI type has three information elements: report type, keepalive, and ____.

The Frame Relay switch is also called the ____.

In Frame Relay, to configure a multipoint subinterface, you map it to multiple remote routers using the same subnet mask, but different ____ numbers.

The Frame Relay map can be built automatically or statically depending on the Frame Relay topology.

In Frame Relay connections, the network device that connects to the Frame Relay switch is known as a(n) ___________________________________.

The most common show commands for monitoring Frame Relay operation are show interface , ____, show frame-relay map , and show frame-relay lmi .

What are the types of encapsulation supported by LMI in Cisco routers?

You can check your Frame Relay configuration by using ____ commands.