Exam 78: Front-Wheel-Drive Transaxle and Cv Joint Service

The part MOST-Likely used to retain a fixed joint to the shaft is a(n):

Front-wheel-drive vehicles typically have ____________________ strut suspensions.

A(n) ____________________ is used when there is a problem with the axle clearing other parts.

When a boot fails, its grease leaks out.

A noisy joint will get quieter with the installation of a new boot and grease.

Provide a brief description of a universal clamp.

Which of the following is LEAST-Likely a type of retaining ring?

On some vehicles it is easier to move the hub away from the stub shaft if the ____________________ is removed first.

Noises coming from the front axle are not usually detected during a test drive.

The part that MOST-Likely rides in a groove in the axle and fits into a corresponding groove inside the inner race is the:

A bad plunge joint will make a clunking sound when starting from a stop, during deceleration, or when braking.

A(n) ____ is located at the end of the fixed-type outer CV joint.

____________________ rings are sometimes installed in a groove to locate or limit movement of a part on a shaft.

A(n) ____ is used to remove some types of splined inner joints.

What is the main difference between conventional automatic transmissions and automatic transaxles?

While having a discussion, Technician A says that the estimated life of a joint is eight hours without lubricant. Technician B says that the estimated life is forty-eight hours. Who is correct?

While having a discussion, Technician A says that you should not use a regular hose clamp to replace a boot clamp. Technician B says that in a pinch, a nylon tie strap can be used for a day or two until a clamp can be purchased. Who is correct?

Which of the following is LEAST-Likely a type of boot clamp?

CV joints are lubed for life.

All of the following statements are true EXCEPT: