Exam 56: Engine Installation, Break-In, and In-Chassis Repairs

An engine that has enough piston-to-valve clearance to prevent contact is MOST-Likely known as a(n):

While having a discussion, Technician A says that if the timing is retarded, engine idle will be too high. Technician B says that if the timing is advanced, the idle will be too low. Who is correct?

Which of the following statements is LEAST-Likely true?

Without dowels, damage, especially to an automatic transmission flexplate, can occur in a short period of time.

When it is not possible to prime the system by removing the distributor, either use a(n) ____________________ or remove all spark plugs and crank the engine.

While having a discussion, Technician A says that to avoid vapor lock, be sure that all fuel lines are positioned at least 1/2" from any heat source. Technician B says that fuel filters should be positioned where they can be cooled by air. Who is correct?

How would you remove the timing cover?

When an engine has a distributor ignition system, the lubrication system can usually be primed before installing the distributor.

Some ____________________ sensors can be triggered by a rattle from a loose valve adjustment or a muffler vibrating against the frame.

What items should be checked when running an engine for the first time?

Older engines with carburetors were susceptible to ____________________ that occurs when fuel vaporizes in a line and a bubble blocks fuel flow.

What precautions should you bear in mind when taking a test drive?

If the oil pan is to be removed with the car on a lift, the tool that is MOST-Likely used to raise the car is a(n):

A faulty ____ often points to a need for head surfacing, cooling system service, or repair to the engine's fuel or ignition system.

How would you adjust the hydraulic lifter lash with the engine idling?

All of the following statements are true EXCEPT:

Oil consumption might not stabilize until all parts have seated to one another. The customer should not be concerned until the vehicle has been driven at least ____ miles.

Late-model cars have ____________________ sensors that will react to the frequency of the vibration of spark knock, retarding spark timing.

Briefly discuss the technique that you would use to help seat the piston rings.

____________________ can be made by cutting the heads off some bolts and using a hacksaw to cut a screwdriver slot in them.