Exam 68: Wheel Alignment Service

While having a discussion, Technician A says that the manufacturers' specifications for maximum allowable steering wheel angle variation are typically + or - 6 degrees. Technician B says that it is normally + or - 8 degrees. Who is correct?

____ is formed by the thrust line and the geometric centerline.

Torque steer happens when a wheel with tie-rods at unequal heights goes over a bump.

How would you conduct a power steering check?

Front wheel bearings on rear-wheel-drive vehicles do not wear out very often. However, bearing misalignment can be caused by a bent spindle; this increases the load on the bearing.