Exam 5: Managing Industrial Networks with Cisco Networking Technologies (IMINS)

Which three of the following components must be elected before the Spanning Tree Protocol can converge in a switched LAN? (Choose three.)

EtherNet/IP is an Ethernet implementation of which protocol?

A small manufacturing company has a Class C network address on the plant floor and needs to create five subnets, each accommodating 25 endpoints. Which subnet mask needs to be configured?

What are two symptoms of duplex mismatch? (Choose two.)

Which of the following correctly pairs the dotted decimal subnet mask with the correct number of binary bits that represent the subnet mask?

Which two ports does EtherNet/IP use to communicate? (Choose two.)

Which prompt is used to configure parameters for the Ethernet ports of an industrial switch?

What should be done with unused conductors in copper unshielded or shielded twisted-pair network cables?

What are two recommended tools or commands that allow you to troubleshoot connectivity between two devices in different IP networks? (Choose two.)

For which three issues should fiber-optic network segments be tested? (Choose three.)

Which option best describes a mechanical, ingress, climatic, chemical and electromagnetic environment that is classified as M3 I3 C3 E3?

Why is SSH preferred over Telnet as a method of accessing a network device to alter or view the configuration?

What are the two most relevant factors in determining the class of administration that is required to maintain the telecommunications infrastructure? (Choose two.)

Which characteristic causes multimode fiber-optic cable to differ from single mode?

What are two benefits of a star network topology? (Choose two.)

Exhibit: Refer to the exhibit. What are three traffic and interconnection requirements for the devices in the exhibit? (Choose three.)

What is the purpose of Spanning Tree Protocol?

Given a ring topology, which loop prevention mechanism provides the fastest reconvergence time after a link failure?

A network administrator has subnetted the 172.16.0.0 network using a subnet mask of 255.255.255.192. A duplicate IP address of 172.16.2.120 has accidentally been configured on a workstation in the network. The technician on the plant floor must assign this workstation a new IP address within that same subnetwork. Which address should be assigned to the workstation?

Exhibit: Refer to the exhibit. An industrial ruggedized network device needs to be installed in the place of the icon labeled Network Device to accommodate a leased line attachment to the Internet. Which network device and interface configuration meets the minimum requirements for this installation?