Question 1

Which type of memory is used to permanently store Cisco IOS Software?

Accepted Answer

A)  NVRAM 
B)  flash 
C)  SRAM 
D)  DRAM 
A)  NVRAM 
B)  flash 
C)  SRAM 
D)  DRAM A

Question 2

What is the primary method for recovering or upgrading a Cisco network device system image?

Accepted Answer

A)  USB storage 
B)  FTP 
C)  the tftpdnld command the tftpdnld command 
D)  the xmodem command xmodem 
A)  USB storage 
B)  FTP 
C)  the tftpdnld command the tftpdnld command 
D)  the xmodem command xmodem C

Question 3

What is the Windows-based program that executes the ping command to test network connectivity?

Accepted Answer

A)  cmd 
B)  Find 
C)  Start 
D)  ipconfig 
A)  cmd 
B)  Find 
C)  Start 
D)  ipconfig A

Question 4

Which two pieces of information about a neighboring device are displayed when you use the CLI command show cdp neighbor? (Choose two.)

Accepted Answer

A)  platform 
B)  uptime 
C)  device ID 
D)  Cisco IOS Software version 
E)  IP address 
A)  platform 
B)  uptime 
C)  device ID 
D)  Cisco IOS Software version 
E)  IP address

Question 5

From the enable mode, which command loads the configuration during the password recovery process on a Cisco router?

Accepted Answer

A)  load_helper 
B)  configure terminal 
C)  copy running-config startup-config 
D)  copy startup-config running-config 
A)  load_helper 
B)  configure terminal 
C)  copy running-config startup-config 
D)  copy startup-config running-config

Question 6

An Ethernet interface is up and the line protocol is down. What are two possible causes? (Choose two.)

Accepted Answer

A)  There is a speed or duplex mismatch with the remote device. 
B)  There is a Layer 2 mismatch in the encapsulation type. 
C)  The Ethernet interface has been manually disabled. 
D)  Keepalives are not being received by the local device. 
E)  The Ethernet cable might not be attached properly. 
A)  There is a speed or duplex mismatch with the remote device. 
B)  There is a Layer 2 mismatch in the encapsulation type. 
C)  The Ethernet interface has been manually disabled. 
D)  Keepalives are not being received by the local device. 
E)  The Ethernet cable might not be attached properly.

Question 7

What is the correct IPv6 address notation?

Accepted Answer

A)  2001:0DB8::/128 
B)  2001:0DB8:0:: 
C)  2001:0DB8::1:1:1:1:1 
D)  2001:0DB8:130F:0000:0000:7000:0000:140B 
A)  2001:0DB8::/128 
B)  2001:0DB8:0:: 
C)  2001:0DB8::1:1:1:1:1 
D)  2001:0DB8:130F:0000:0000:7000:0000:140B

Question 8

Which type of physical connector does a Gigabit Ethernet port typically use?

Accepted Answer

A)  RJ-9 
B)  RJ-45 
C)  DB-25 
D)  RJ-11 
A)  RJ-9 
B)  RJ-45 
C)  DB-25 
D)  RJ-11

Question 9

Which two commands are valid for copying a saved configuration to RAM? (Choose two.)

Accepted Answer

A)  copy startup-config running-config 
B)  copy running-config startup-config 
C)  copy tftp running-config 
D)  copy running-config tftp 
E)  copy tftp startup-config 
A)  copy startup-config running-config 
B)  copy running-config startup-config 
C)  copy tftp running-config 
D)  copy running-config tftp 
E)  copy tftp startup-config

Question 10

Which two IPv4 addresses can be assigned to a host computer? (Choose two.)

Accepted Answer

A)  255.255.255.255 
B)  10.1.1.20 
C)  0.0.0.0 
D)  192.168.10.15 
E)  292.10.3.4 
A)  255.255.255.255 
B)  10.1.1.20 
C)  0.0.0.0 
D)  192.168.10.15 
E)  292.10.3.4

Question 11

What are two components of a WAN connection? (Choose two.)

Accepted Answer

A)  CSU/DSU 
B)  router 
C)  bridge 
D)  hub 
E)  switch 
A)  CSU/DSU 
B)  router 
C)  bridge 
D)  hub 
E)  switch

Question 12

Which Cisco CPAK 100GBASE module supports Multimode Fiber cable?

Accepted Answer

A)  Cisco CPAK-100G-CWDM4 
B)  Cisco CPAK-100G-LR4 
C)  Cisco CPAK-100G-ER4L 
D)  Cisco CPAK-100G-SR4 
A)  Cisco CPAK-100G-CWDM4 
B)  Cisco CPAK-100G-LR4 
C)  Cisco CPAK-100G-ER4L 
D)  Cisco CPAK-100G-SR4

Question 13

Which two ports on a laptop are used to gain console access to a Cisco switch? (Choose two.)

Accepted Answer

A)  DB-9 
B)  USB 
C)  DVI 
D)  RJ-11 
E)  RJ-45 Ethernet 
A)  DB-9 
B)  USB 
C)  DVI 
D)  RJ-11 
E)  RJ-45 Ethernet

Question 14

Which router port is used for dial-in access to the router for CLI management purposes and does not usually pass normal network traffic?

Accepted Answer

A)  Fast Ethernet 
B)  channelized serial 
C)  AUX 
D)  Gigabit Ethernet 
A)  Fast Ethernet 
B)  channelized serial 
C)  AUX 
D)  Gigabit Ethernet

Question 15

Which Windows-based text editor is preferred for working with a simple text document, such as a Cisco configuration?

Accepted Answer

A)  Microsoft Word 
B)  Microsoft Notepad 
C)  Microsoft Access 
D)  Microsoft Excel 
A)  Microsoft Word 
B)  Microsoft Notepad 
C)  Microsoft Access 
D)  Microsoft Excel

Question 16

Which type of port on a laptop is used to connect to an Ethernet port on a Cisco switch?

Accepted Answer

A)  DVI 
B)  RJ-11 
C)  DB-9 
D)  RJ-45 
A)  DVI 
B)  RJ-11 
C)  DB-9 
D)  RJ-45

Question 17

The pins on an RJ-45 cable plug are numbered from 1 through 8. When the metal pins of the plug are facing toward you, pin 1 is the leftmost pin. Which two sets of pins are looped on an RJ-45 56K loopback plug? (Choose two.)

Accepted Answer

A)  pins 2 and 7 
B)  pins 2 and 8 
C)  pins 2 and 5 
D)  pins 1 and 7 
E)  pins 1 and 4 
A)  pins 2 and 7 
B)  pins 2 and 8 
C)  pins 2 and 5 
D)  pins 1 and 7 
E)  pins 1 and 4

Question 18

Which command sends an echo request packet to the target host and then waits for an echo response message?

Accepted Answer

A)  echo 
B)  access 
C)  ping 
D)  connect 
A)  echo 
B)  access 
C)  ping 
D)  connect

Question 19

What does Cisco use for Return Materials Authorization tracking of field-replaceable parts?

Accepted Answer

A)  product number 
B)  serial number 
C)  RMA number 
D)  FRU number 
A)  product number 
B)  serial number 
C)  RMA number 
D)  FRU number

Question 20

Which type of Cisco console cable is used to connect a laptop to the console port on a Cisco router?

Accepted Answer

A)  straight-through 
B)  fiber 
C)  crossover 
D)  rollover 
A)  straight-through 
B)  fiber 
C)  crossover 
D)  rollover

Exam 2: Cisco Certified Technician Routing & Switching (RSTECH)

Which type of memory is used to permanently store Cisco IOS Software?

What is the primary method for recovering or upgrading a Cisco network device system image?

What is the Windows-based program that executes the ping command to test network connectivity?

Which two pieces of information about a neighboring device are displayed when you use the CLI command show cdp neighbor? (Choose two.)

From the enable mode, which command loads the configuration during the password recovery process on a Cisco router?

An Ethernet interface is up and the line protocol is down. What are two possible causes? (Choose two.)

What is the correct IPv6 address notation?

Which type of physical connector does a Gigabit Ethernet port typically use?

Which two commands are valid for copying a saved configuration to RAM? (Choose two.)

Which two IPv4 addresses can be assigned to a host computer? (Choose two.)

What are two components of a WAN connection? (Choose two.)

Which Cisco CPAK 100GBASE module supports Multimode Fiber cable?

Which two ports on a laptop are used to gain console access to a Cisco switch? (Choose two.)

Which router port is used for dial-in access to the router for CLI management purposes and does not usually pass normal network traffic?

Which Windows-based text editor is preferred for working with a simple text document, such as a Cisco configuration?

Which type of port on a laptop is used to connect to an Ethernet port on a Cisco switch?

The pins on an RJ-45 cable plug are numbered from 1 through 8. When the metal pins of the plug are facing toward you, pin 1 is the leftmost pin. Which two sets of pins are looped on an RJ-45 56K loopback plug? (Choose two.)

Which command sends an echo request packet to the target host and then waits for an echo response message?

What does Cisco use for Return Materials Authorization tracking of field-replaceable parts?

Which type of Cisco console cable is used to connect a laptop to the console port on a Cisco router?

Supporting Cisco Data Center System Devices (DCTECH)

Understanding Cisco Cybersecurity Operations Fundamentals (CBROPS)

Cisco Certified Network Associate (CCNA)

Managing Industrial Networks with Cisco Networking Technologies (IMINS)

DevNet Associate (DEVASC)

Conducting Forensic Analysis and Incident Response Using Cisco CyberOps Technologies (CBRFIR)

Implementing Cisco Enterprise Advanced Routing and Services (ENARSI)

Implementing Cisco SD-WAN Solutions (ENSDWI)

Designing Cisco Enterprise Networks (ENSLD)

Designing Cisco Enterprise Wireless Networks (300-425 ENWLSD)

Implementing Cisco Enterprise Wireless Networks (300-430 ENWLSI)

Automating Cisco Enterprise Solutions (ENAUTO)

Implementing Cisco Service Provider Advanced Routing Solutions (SPRI)

Implementing Cisco Service Provider VPN Services (SPVI)

Designing Cisco Data Center Infrastructure (DCID)

Troubleshooting Cisco Data Center Infrastructure (DCIT)

Implementing Cisco Application Centric Infrastructure (DCACI)

Configuring Cisco MDS 9000 Series Switches (DCSAN)

Implementing Cisco Application Centric Infrastructure - Advanced

Automating Cisco Data Center Solutions (DCAUTO)

Securing Networks with Cisco Firepower (300-710 SNCF)

Implementing and Configuring Cisco Identity Services Engine (300-715 SISE)

Securing Email with Cisco Email Security Appliance (300-720 SESA)

Securing the Web with Cisco Web Security Appliance (300-725 SWSA)

Implementing Secure Solutions with Virtual Private Networks (SVPN 300-730)

Automating Cisco Security Solutions (SAUTO)

Implementing Cisco Collaboration Applications (CLICA)

Implementing Cisco Advanced Call Control and Mobility Services (CLASSM)

Implementing Cisco Collaboration Cloud and Edge Solutions

Implementing Cisco Collaboration Conferencing

Automating Cisco Collaboration Solutions (CLAUTO)

Implementing DevOps Solutions and Practices using Cisco Platforms (DEVOPS)

Developing Solutions Using Cisco IoT and Edge Platforms (DEVIOT)

Developing Applications for Cisco Webex and Webex Devices (DEVWBX)

Performing CyberOps Using Core Security Technologies (CBRCOR)

Implementing Cisco Enterprise Network Core Technologies (ENCOR)

Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR)

Implementing and Operating Cisco Data Center Core Technologies (DCCOR)

Implementing and Operating Cisco Security Core Technologies

Implementing Cisco Collaboration Core Technologies (CLCOR)

Developing Applications using Cisco Core Platforms and APIs (DEVCOR)

CCDE Design Written

Deploying Cisco Unified Contact Center Express

Cisco Meraki Solutions Specialist

Securing Cisco Networks with Sourcefire FireAMP Endpoints

Designing Cisco Unified Contact Center Enterprise (UCCED)

Implementing and Supporting Cisco Unified Contact Center Enterprise (UCCEIS)

Cisco Collaboration SaaS Authorization Exam

Cisco Security Architecture for System Engineers

Adopting The Cisco Business Architecture Approach (DTBAA)

Cisco Customer Success Manager (CSM)

Mastering The Cisco Business Architecture Discipline (DTBAD)

Filters