Exam 8: Implementing Cisco Enterprise Advanced Routing and Services (ENARSI)

Refer to the exhibit. AAA server 10.1.1.1 is configured with the default authentication and accounting settings, but the switch cannot communicate with the server. Which action resolves this issue?

What are two purposes of using IPv4 and VPNv4 address-family configurations in a Layer 3 MPLS VPN? (Choose two.)

Which transport layer protocol is used to form LDP sessions?

Refer to the exhibit. Which control plane policy limits BGP traffic that is destined to the CPU to 1 Mbps and ignores BGP traffic that is sent at higher rate?

Refer to the exhibit. A network engineer for AS64512 must remove the inbound and outbound traffic from link A during maintenance without closing the BGP session so that there is still a backup link over link A toward the ASN. Which BGP configuration on R1 accomplishes this goal?

Refer to the exhibit. Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64?

Refer to the exhibit. Which two actions restrict access to router R1 by SSH? (Choose two.)

Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected through a common fiber?

What are two functions of LDP? (Choose two.)

What are two functions of IPv6 Source Guard? (Choose two.)

Which list defines the contents of an MPLS label?

What is a prerequisite for configuring BFD?

Which command allows traffic to load-balance in an MPLS Layer 3 VPN configuration?

An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table. What should be configured to accomplish this task?