Exam 39: Implementing and Operating Cisco Data Center Core Technologies (DCCOR)

After you analyze your network environment, you decide to implement a full separation model for Internet access and MPLS L3VPN services. For which reason do you make this decision?

Refer to the exhibit. This output is included at the end of an output that was provided by a device using NETCONF. What does the code show?

Which two actions describe LSP delegation to PCE servers? (Choose two.)

While implementing TTL security, you issue the PE(config-router-af)#neighbor 2.2.2.2 ttl-security hops 2 command. After you issue this command, which BGP packets does the PE accept?

Refer to the exhibit. Which configuration must be applied to each of the four routers on the network to reduce LDP LIB size and advertise label bindings for the /32 loopback IP space only?

Refer to the exhibit. A network operator needs to shut down interface Gi0/0/0/2 for maintenance. What occurs to the interface states of Gi0/0/0/0 and Gi0/0/0/1?

Refer to the exhibits. Which information is provided for traceback analysis when this configuration is applied?

Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?

Refer to the exhibit. On R1, which output does the show isis neighbors command generate?

Refer to the exhibit. An engineer is preparing to implement link aggregation configuration. Which statement about this configuration is true?

Refer to the exhibit. After implementing a new design for the network, a technician reviews the pictures CLI output as part of the MOP. Which two elements describe what the technician can ascertain from the ImpNull output? (Choose two.)

Refer to the exhibit. Based on the show command output, which result is true after BGP session is established?

Refer to the exhibit. This configuration is being applied on an IOS XR router. Which statement about this configuration is true?

When configuring traffic engineering tunnels in Cisco MPLS core network, you see the traffic is not tacking the expected path in the core. Which command do you use to quickly check path of a TE tunnel?

Which service is a VNF role?

Refer to the exhibit. An engineer is implementing Auto-RP and reviewing the configuration of the PE-A. Which configuration permits Auto-RP messages to be forwarded over this interface?

You are creating new Cisco MPLS TE tunnels. Which type of RSVP message does the headend router send to reserve bandwidth on the path to the tailend router?

Refer to the exhibit. While troubleshooting the network, a network operator with an employee id: 1234:55:678 is trying to ping XR1. Which result should the operator expect when trying to ping to an XR1 local address?

Refer to the exhibit. What is the effect of this configuration applied on the IOS XR router?

Refer to the exhibit. A network engineer is implementing an OSPF configuration. Based on the output, which statement is true?