Exam 15: Implementing Cisco Service Provider VPN Services (SPVI)

You try to configure MPLS VPN VRF Selection based on a source IP address on an interface that has VRF configured, but you receive an error. Which action must you take to correct the problem?

Which tool identifies the point of failure in a P2MP LSP from the ingress LSR?

Which two BGP attributes prevent loops in a route reflector environment? (Choose two.)

What is the primary function of a VRF on a router?

What must match in the EVPN and L2VPN configuration mode when configuring EVPN native in a router?

With Layer 3 MPLS VPN implementations on Cisco IOS XR PE routers, an interface is assigned to a VRF using the vrf command in which configuration mode?

Refer to the exhibit. Which statement describes the result of this configuration?

Refer to the exhibit. A technician is troubleshooting a connectivity issue and notices that there is no IS-IS adjacency between R1 and R2. What can the technician change to bring the IS-IS adjacency up?

While troubleshooting an AToM L2VPN service, a network consultant notices that the AC Layer 2 encapsulations are different. Which action should the consultant take in order to make the MPLS L2VPN work?