Exam 23: Implementing and Configuring Cisco Identity Services Engine (300-715 SISE)

Which policy rule is included in the deployment of a local DMZ during the initial deployment of a Cisco NGFW through the Cisco FMC GUI?

Which command is run at the CLI when logged in to an FTD unit, to determine whether the unit is managed locally or by a remote FMC server?

A network engineer is configuring URL Filtering on Cisco FTD. Which two port requirements on the FMC must be validated to allow communication with the cloud service? (Choose two.)

When creating a report template, how are the results limited to show only the activity of a specific subnet?

Which two packet captures does the FTD LINA engine support? (Choose two.)

Which protocol establishes network redundancy in a switched Firepower device deployment?

An engineer currently has a Cisco FTD device registered to the Cisco FMC and is assigned the address of 10.10.50.12. The organization is upgrading the addressing schemes and there is a requirement to convert the addresses to a format that provides an adequate amount of addresses on the network. What should the engineer do to ensure that the new addressing takes effect and can be used for the Cisco FTD to Cisco FMC connection?

An engineer is troubleshooting application failures through an FTD deployment. While using the FMC CLI, it has been determined that the traffic in question is not matching the desired policy. What should be done to correct this?

An engineer is building a new access control policy using Cisco FMC. The policy must inspect a unique IPS policy as well as log rule matching. Which action must be taken to meet these requirements?

Which two dynamic routing protocols are supported in Cisco FTD without using FlexConfig? (Choose two.)

Which command should be used on the Cisco FTD CLI to capture all the packets that hit an interface?

An engineer is investigating connectivity problems on Cisco Firepower that is using service group tags. Specific devices are not being tagged correctly, which is preventing clients from using the proper policies when going through the firewall. How is this issue resolved?

Which command must be run to generate troubleshooting files on an FTD?

An engineer is setting up a new Firepower deployment and is looking at the default FMC policies to start the implementation. During the initial trial phase, the organization wants to test some common Snort rules while still allowing the majority of network traffic to pass. Which default policy should be used?

A network administrator is configuring SNORT inspection policies and is seeing failed deployment messages in Cisco FMC. What information should the administrator generate for Cisco TAC to help troubleshoot?

While configuring FTD, a network engineer wants to ensure that traffic passing though the appliance does not require routing or VLAN rewriting. Which interface mode should the engineer implement to accomplish this task?

Which Firepower feature allows users to configure bridges in routed mode and enables devices to perform Layer 2 switching between interfaces?

What is a valid Cisco AMP file disposition?

What is the maximum bit size that Cisco FMC supports for HTTPS certificates?

An organization has noticed that malware was downloaded from a website that does not currently have a known bad reputation. How will this issue be addressed globally in the quickest way possible and with the least amount of impact?