Exam 38: Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR)

arrow
  • Select Tags
search iconSearch Question
flashcardsStudy Flashcards
  • Select Tags

Refer to the exhibit. Refer to the exhibit.   Security policy requires all idle exec sessions to be terminated in 600 seconds. Which configuration achieves this goal? Security policy requires all idle exec sessions to be terminated in 600 seconds. Which configuration achieves this goal?

(Multiple Choice)
4.8/5
(37)

Which statements about PMTUD is true?

(Multiple Choice)
4.8/5
(44)

Refer to the exhibit. Refer to the exhibit.   What is the JSON syntax that is formed from the data? What is the JSON syntax that is formed from the data?

(Multiple Choice)
4.9/5
(39)

Which controller is the single plane of management for Cisco SD-WAN?

(Multiple Choice)
4.9/5
(38)

What is one fact about Cisco SD-Access wireless network infrastructure deployments?

(Multiple Choice)
4.8/5
(24)

An engineer is concerned with the deployment of a new application that is sensitive to inter-packet delay variance. Which command configures the router to be the destination of jitter measurements?

(Multiple Choice)
4.8/5
(28)

An engineer must configure an ACL that permits packets which include an ACK in the TCP header. Which entry must be included in the ACL?

(Multiple Choice)
4.8/5
(33)

Refer to the exhibit. Refer to the exhibit.   What is the effect of this configuration? What is the effect of this configuration?

(Multiple Choice)
4.9/5
(34)

Which three statements about EVCs are true? (Choose three.)

(Multiple Choice)
4.9/5
(36)

What is a benefit of using a Type 2 hypervisor instead of a Type 1 hypervisor?

(Multiple Choice)
4.7/5
(29)

A network administrator is implementing a routing configuration change and enables routing debugs to track routing behavior during the change. The logging output on the terminal is interrupting the command typing process. Which two actions can the network administrator take to minimize the possibility of typing commands incorrectly? (Choose two.)

(Multiple Choice)
4.8/5
(39)

Refer to the exhibit. Refer to the exhibit.   A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration excerpt of SW3, what is the cause of the problem? A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration excerpt of SW3, what is the cause of the problem?

(Multiple Choice)
4.9/5
(40)

What is a requirement for an Ansible-managed node?

(Multiple Choice)
4.8/5
(40)

What is the difference between the enable password and the enable secret password when service password encryption is enabled on an IOS device?

(Multiple Choice)
4.9/5
(41)

Which two conditions are required for tracking the interface IP routing state? (Choose two.)

(Multiple Choice)
4.8/5
(43)

A company has an existing Cisco 5520 HA cluster using SSO. An engineer deploys a new single Cisco Catalyst 9800 WLC to test new features. The engineer successfully configures a mobility tunnel between the 5520 cluster and 9800 WLC. Clients connected to the corporate WLAN roam seamlessly between access points on the 5520 and 9800 WLC. After a failure on the primary 5520 WLC, all WLAN services remain functional; however, clients cannot roam between the 5520 and 9800 controllers without dropping their connection. Which feature must be configured to remedy the issue?

(Multiple Choice)
4.8/5
(42)

When a wireless client roams between two different wireless controllers, a network connectivity outage is experienced for a period of time. Which configuration issue would cause this problem?

(Multiple Choice)
4.9/5
(36)

Which action is the vSmart controller responsible for in an SD-WAN deployment?

(Multiple Choice)
4.9/5
(39)

If a VRRP master router fails, which router is selected as the new master router?

(Multiple Choice)
4.9/5
(42)

Refer to the exhibit. Refer to the exhibit.   An engineer must modify the access control list EGRESS to allow all IP traffic from subnet 10.1.10.0/24 to 10.1.2.0/24. The access control list is applied in the outbound direction on router interface GigabitEthernet 0/1. Which configuration command set will allow this traffic without disrupting existing traffic flows? An engineer must modify the access control list EGRESS to allow all IP traffic from subnet 10.1.10.0/24 to 10.1.2.0/24. The access control list is applied in the outbound direction on router interface GigabitEthernet 0/1. Which configuration command set will allow this traffic without disrupting existing traffic flows?

(Multiple Choice)
4.9/5
(40)
Showing 181 - 200 of 260
close modal

Filters

  • Essay(0)
  • Multiple Choice(0)
  • Short Answer(0)
  • True False(0)
  • Matching(0)