Exam 38: Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR)

A client with IP address 209.165.201.25 must access a web server on port 80 at 209.165.200.225. To allow this traffic, an engineer must add a statement to an access control list that is applied in the inbound direction on the port connecting to the web server. Which statement allows this traffic?

Where is radio resource management performed in a Cisco SD-Access wireless solution?

Which requirement for an Ansible-managed node is true?

Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration except of SW3, what is the cause of the problem?

Refer to the exhibit. The Main1 and Branch1 switches are connected directly over an MPLS pseudowire, and both run UDLD. After router B1 reloads because of a power failure, the pseudowire is restored. However, the Branch1 switch is unable to reach the Main1 switch. Which two actions can you take to restore connectivity and prevent the problem from recurring? (Choose two.)

Refer to the exhibit. Which IP address becomes the active next hop for 192.168.102.0/24 when 192.168.101.2 fails?

Refer to the exhibit. What are two effects of this configuration? (Choose two.)

Which two statements about single-hub DMVPN are true? (Choose two.)

Which antenna type should be used for a site-to-site wireless connection?

When a wired client connects to an edge switch in an SDA fabric, which component decides whether the client has access to the network?

Refer to the exhibit. PC-1 must access the web server on port 8080. To allow this traffic, which statement must be added to an access control list that is applied on SW2 port G0/0 in the inbound direction?

Which LISP infrastructure device provides connectivity between non-LISP sites and LISP sites by receiving non-LISP traffic with a LISP site destination?

Which encryption hashing algorithm does NTP use for authentication?

What is provided by the Stealthwatch component of the Cisco Cyber Threat Defense solution?

Which method displays text directly into the active console with a synchronous EEM applet policy?

Which statement explains why Type 1 hypervisor is considered more efficient than Type2 hypervisor?

Wireless users report frequent disconnections from the wireless network. While troubleshooting, a network engineer finds that after the user is disconnected, the connection re-establishes automatically without any input required. The engineer also notices these message logs: AP 'AP2' is down. Reason: Radio channel set. 6:54:04 PM AP 'AP4' is down. Reason: Radio channel set. 6:44:49 PM AP 'AP7' is down. Reason: Radio channel set. 6:34:32 PM Which action reduces the user impact?

What is the role of the vSmart controller in a Cisco SD-WAN environment?

What it the purpose of the LISP routing and addressing architecture?

Which deployment option of Cisco NGFW provides scalability?