Exam 44: Deploying Cisco Unified Contact Center Express

An enterprise company is attaching to a new Gigabit Ethernet-based link from the local service provider. This connection must have a 150 Mbps committed information rate. For the design of this new service, which QoS mechanism must be used to ensure low packet loss within the service provider network?

Refer to the exhibit. "Pass Any Exam. Any Time." - www.actualtests.com 58 Cisco 352-001 Exam What limitations exist in this design, given that the access layer devices are expected to steadily increase by two devices per week for the next year?

Which two headend router scalability factors should be considered when designing a DMVPN network solution that uses a hub-and-spoke topology? (Choose two.)

A many-to-many enterprise messaging application is using multicast as a transport mechanism. As part of the network design for this application, which multicast address should be used, according to best practices outlined in RFC 2365?

Which design consideration of policy-based routing is true?

Tom is a network administrator for the P4S Ltd. He is having problems with redistribution routing loops between two EIGRP processes. After studying the configurations, he determined there is no filtering configured on the routes being redistributed. In order to avoid having a single point of failure, there are three routers configured to redistribute between the two routing protocols. Which one of the following items is a solution to minimize management complexity?

You are a network technician. A service provider is providing a QoS-based transport service. Three classes have been defined in the core, including an Expedited Forwarding (EF) class for VoIP traffic. Which tool will you use at the ingress for the EF class?

Which two statements describe how including Cisco IPoDWDM proactive protection in an optical design would minimize packet loss in the event of a fiber cut? (Choose two).

Study the following exhibit carefully. A customer is deploying three unicast applications (voice, video, and data) between these two PCs. OSPF is performing as a single area, Area 0, from P4S-R1 to P4S-R2. Three MPLS TE tunnels have been set up between P4S-R1 and P4S-R2. Each tunnel carries only one application's traffic. What is needed on P4S-R1 and P4S-R2 to separate the three types of traffic into the appropriate tunnels?

You work for a large enterprise network that spans many remote locations and uses EIGRP as its only routing protocol. Recently, the network grew too rapidly and it is having a lot of SIA problems, which impact the company business. In which two ways should you redesign the network to solve this problem? (Choose two.)

Which two are IoT sensor-specific constraints? (Choose two.)

You are working on a network design plan for a company with approximately 2000 sites. The sites will be connected using the public Internet. You plan to use private IP addressing in the network design, which will be routed without NAT through an encrypted WAN network. Some sites will be connected to the Internet with dynamic public IP addresses, and these addresses may change occasionally. Which VPN solution will support these design requirements?

You are the lead IP/MPLS network designer of a service provider called XYZ. You are leading a design discussion regarding IPv6 implementation in the XYZ MPLS network, using MPLS 6PE/6VPE techniques. Currently, XYZ provides IPv4 multicast services over an MPLS network by using MVPN, and would like to provide parallel IPv6 multicast services. Which three multicast solutions should be enabled? (Choose three.)

You are designing an Out of Band Cisco Network Admission Control, Layer 3 Real-IP Gateway deployment for a customer. Which VLAN must be trunked back to the Clean Access Server from the access switch?

Which item can reduce IP address spoofing effectively and dynamically?

Your network operations team is deploying Access Control Lists (ACLs) across your Internet gateways. They wish to place an ACL inbound on the Internet gateway interface facing the core network (the "trusted" interface). Which one of these addresses would the ACL need for traffic sourced from the inside interface, to match the source address of the traffic?

AS100 and AS200 each have two peering points in different parts of their network. AS100 would like to use one of the links and keep the other link as backup. What should be changed for the design inside AS100 for prefixes received from AS200?

"Pass Any Exam. Any Time." - www.actualtests.com 15 Cisco 352-001 Exam During a network design review, it is recommended that the network with a single large area should be broken up into a backbone and multiple nonbackbone areas. There are differing opinions on how many ABRs are needed for each area for redundancy. What would be the impact of having additional ABRs per area?

Study the following exhibit carefully, in which area should you put the link between router P4S-RA and router P4S-RB in order to avoid suboptimal routing?

You have been tasked to create a Layer 2 network design that uses vPC to provide resiliency and avoid loops. vPC removes Layer 2 loops while providing redundancy through which mechanism?