Exam 44: Deploying Cisco Unified Contact Center Express

Which option is a critical mechanism to optimize convergence speed when using MPLS FRR?

Which option is best suited to maintain Layer 3 separation in a multitenant data center design?

Which two mechanisms ensure that a network design provides fast path failure detection? (Choose two.)

Which BFD design consideration is true?

A customer is using a service provider to provide a WAN backbone for a 30-site network. In establishing the network, the customer must work within these constraints: What can the customer do so that multicast traffic is NOT flooded to all sites?

You are designing a traffic monitoring and analysis system for a customer. Which traffic monitoring technique would you recommend to place the least amount of burden on the network infrastructure?

A large ISP is analyzing the following IGP requirements: The network must be resilient against unstable MTU in one side for newly deployed transmission equipment. The network must support MPLS traffic engineering solution for future use. Which IGP must be selected and why?

Recently, the P4S company has deployed a security audit and determined that a configuration management system is needed. Which two purposes can the system provide? (Choose two.)

You have designed a network to support two offices connected by a T1. Your router serial interfaces will be configured with encapsulation PPP. What will happen to your EIGRP neighbors if there is an LCP failure once your network is implemented?

In this network presented in the following exhibit, configuring all routers to run OSPF on all interfaces. If you examine the OSPF database on P4S-R4, in which LSA will you find 10.1.5.0/24?

For the following options, which deployment can provide the least amount of downtime and also allow for dual active-active hubs?

During a corporate merger, a network designer is asked for a solution that will provide connectivity between the two enterprise networks. The solution must have the ability to support video sessions so that the CEO can message merger activities to the employees. The designer decides to consider multicast as a transport with MSDP to provide redundancy. Which transport feature does the network designer need to apply to the interconnecting firewall to ensure that Source-Active messages between the MSDP peers can be sent in both enterprise networks?

Voice traffic between two campus enterprise networks is growing. The network designers decide to add a second 10-Mb Metro Ethernet service parallel to their original 10-Mb service in order to provide more bandwidth and diversity. The QoS profile will be the same on the new 10-Mb service due to the voice stability on the first Metro Ethernet link. When the second link is added to the OSPF domain, which traffic design consideration would have the most impact on the voice traffic when both links are active?

In the network presented below, configure routers P4S-RE and P4S-RF as route reflector clients of router P4S-RA. When router P4S-RE transmits a route to router P4S-RA, which router or routers will router P4S-RA send an update to?

During a DoS attack, which IPv4 addressing and routing scheme could increase the availability of a network service?

Your customer wants to migrate their network from IPv4 to IPv6. They currently have Control Plane Policing deployed to protect their network devices from illegitimate ICMP traffic flooding. How do you adjust Control Plane Policing for ICMPv6 traffic, if it should be adjusted at all?

Which two statements are true about MLP interleaving? (Choose two.)

"Pass Any Exam. Any Time." - www.actualtests.com 43 Cisco 352-001 Exam You are the lead IP/MPLS network designer of a service provider called XYZ. You are leading a design discussion regarding IPv6 implementation in the XYZ MPLS network, using MPLS 6PE/6VPE techniques. Currently, XYZ provides IPv4 multicast services over an MPLS network by using MVPN, and would like to provide parallel IPv6 multicast services. Which three multicast solutions should be enabled? (Choose three.)

Which method can most efficiently implement IP multicast in a network without using RPs?

You are the SAN designer for the ABC Company. Due to budget constraints, there is increased pressure by management to further optimize server utilization by implementing virtualization technologies on all servers and increase virtual machines density. Faced with some SAN challenges, the server team requests your help in the design and implementation of the SAN in the new virtualized environment. In which two ways can NPIV be used in your proposed design? (Choose two.)