Exam 44: Deploying Cisco Unified Contact Center Express

"Pass Any Exam. Any Time." - www.actualtests.com 75 Cisco 352-001 Exam Your company plans to implement an Internet gateway router that is performing NAT. This same gateway will be terminating various IPsec tunnels to other remote sites. Which address type is appropriate for the ACL that will govern the sources of traffic entering the tunnel in the inside interface?

Which routing protocol requires minimal reconfiguration when establishing a MPLS Layer 3 VPN over DMVPN encrypted using GETVPN?

You have been hired to redesign a network due to issues with congestion. How will a router function if the QoS mechanism of congestion avoidance is integrated into the existing network design? "Pass Any Exam. Any Time." - www.actualtests.com 34 Cisco 352-001 Exam

Refer to the exhibit. A new IPv4 multicast-based video-streaming service is being provisioned. During the design-validation tests, you realize that the link between the two buildings is carrying multicast traffic even when there are no receivers connected to the switch in Building B and despite IGMP snooping being enabled on both Layer 2 switches and IGMPv2 runs on the hosts. Which design change will prevent the multicast traffic from being unnecessarily flooded throughout the campus network?

Study the exhibit carefully. All link costs are the same in this network. If running EIGRP on all routers, what will happen if router P4S-RB's fail to connect to 10.1.0.0/24?

Which description is correct about how MTU mismatches are addressed in the IS-IS neighbor-formation process?

The campus consists of four main buildings with a single router at each location. A single Ethernet connection exists between each building. Which two EIGRP metrics should be made equal in the network redesign to ensure proper load sharing? (Choose two.)

A Service Provider network designer is considering the use of the G.8032 Ethernet Ring Protection mechanism in order to provide resiliency in the network. Which three concepts will be supported with the implementation G.8032? (Choose three.)

What is the advantage of using a router instead of a switch when implementing Hierarchical VPLS (H-VPLS) CE devices?

A service provider has a Resilient Ethernet Protocol ring running as a metro backbone between its locations in one city. A customer wants to connect one site with one box redundant to the Resilient Ethernet Protocol ring at two different service provider locations. How can this be done without producing any Layer 2 loops within the network design? "Pass Any Exam. Any Time." - www.actualtests.com 6 Cisco 352-001 Exam

A network administrator is in charge of multiple IPsec VPN headend devices that service thousands of remote connectivity, point-to-point, IPsec/GRE tunnels. During a recent power outage, in which it was found that a backup power supply in one of those headend devices was faulty, one of the headend routers suffered a complete shutdown event. When the router was successfully recovered, remote users found intermittent connectivity issues that went away after several hours. Network operations staff accessed the headend devices and found that the recently recovered unit was near 100% CPU for a long period of time. How would you redesign the network VPN headend devices to prevent this from happening again in the future?

The network administrator of a branch office network has decided to deploy Unicast RPF at the access layer. He insists that the design must guarantee that all the packets arriving on the router interfaces are assigned to the same interface subnet. Which mode of Unicast RPF would you recommend as the lead network designer?

OSPF is implemented over a pseudowire Layer 2 VPN. Which statement about this design implementation is true?

A network design includes a long signaling delay in notifying the Layer 3 control plane that an interface has failed. Which two of these actions would reduce that delay? (Choose two.)

Which two are characteristics of RSVP? (Choose two.)

If a network design must support rapid convergence on half-duplex interfaces, which IEEE 802.1w capability should be used?

A company has these requirements for access to their wireless and wired corporate LANs using 802.1x: Which solution meets these requirements?

Refer to the exhibit. You must ensure that both core A and core B devices have only the minimum information required for reaching the spoke routers yet maintain full reachability during network failures. Which of the following design solutions accomplishes these requirements?

A large service provider offers VoIP and Video services to business customers. Which three areas should the service provider monitor related to these services? (Choose three.)

A protected DWDM circuit with disjoint fiber routes and guaranteed restoration times is ordered to connect two hub sites. Which BFD design consideration is true in relation to protected DWDM?