Exam 44: Deploying Cisco Unified Contact Center Express

Which mechanism does OSPF use to prevent loops in an MPLS Layer 3 VPNs environment?

Refer to the exhibit. Acme Corporation hired you as a network designer to upgrade their network so that it supports IPv4 and IPv6 multicast. Which two protocols are needed on the LAN switch? (Choose two.)

Which two reasons are for instrumenting your network and network devices to collect performance data? (Choose two.)

MPLS TE tunnel is created on a PE-router and terminates at another PE-router. Study the exhibit carefully. A service provider with a multi-area OSPF environment would like to set up Cisco MPLS TE tunnels among provider edge routers across area boundaries. The LSPs are configured with bandwidth constraints and explicit loose route hops as indicated by the arrows in the following path: PE1 -> ABR1 -> ABR2 -> PE2 The network has enough resources to set up the Cisco MPLS TE tunnel from PE1 to PE2. For which devices will PE1 run CSPF?

Which two aspects are considered when designing a dual hub, dual DMVPN cloud topology? (Choose two.)

Which resource will be targeted by a TCP SYN flood attack?

Refer to the exhibit. Your company wants to sell its marketing research data to its strategic partners. All strategic partners currently have a Multipoint GRE VPN setup to your hub remote access routers, and are running a separate OSPF process over the Multipoint GRE VPN with you. Your internal IGP is also OSPF, and the internal application used to access the marketing research data is located within your company's data center. Which solution ensures the strategic partners are provided with only the access they need, and that both organization's routing designs are not negatively affected?

You are a network technician. After examining the following exhibit, can you tell me what the label at the top of the label stack for the IP Packet is when it leaves PE2 for the 10.1.1.0/24 network?

You are reviewing a new data center design for a customer. They chose to leverage a tunnel-based overlay technology for quick deployment and multitenant security. Which design concern can affect the availability across the data center?

"Pass Any Exam. Any Time." - www.actualtests.com 61 Cisco 352-001 Exam Refer to the exhibit. When designing an MPLS-based LAN extension between DC-1 and DC-2, what are three advantages of deploying VSS? (Choose three.)

A network designer wants to improve a company network design due to multiple network crashes. Which technology would allow for the restore of a network connection without informing the Layer 3 protocol?

You are the Cisco Network Designer in P4S. In your company site, a NAS is both physically and logically in the traffic path. The NAS identifies clients solely based on their MAC addresses. In which access mode has this NAS been configured to operate?

Refer to the exhibit. "Pass Any Exam. Any Time." - www.actualtests.com 23 Cisco 352-001 Exam You are developing a migration plan to enable IPv6 in your IPv4 network. Starting at R3 and assuming default IS-IS operations, what is likely to happen when you enable IPv6 routing on the link from R3 to R2?

A network has several routers running IS-IS Layer 1/Layer 2 mode on the same Ethernet segment. Which action reduces the number of the IS-IS adjacencies to a minimum in this segment?

When a router running EIGRP takes alternate paths into consideration, which ones will it consider loop-free?

Refer to the exhibit. Your company designed a network to allow server VLANs to span all access switches in a data center. In the design, Layer 3 VLAN interfaces and HSRP are configured on the aggregation switches. Which two features will improve STP stability within the network design? (Choose two.)

Refer to the exhibit. In this network design, where should summarization occur to provide the best summarization and optimal paths during a single-failure incident as well as during normal operation?

Your company experienced a number of network incidents that had a significant impact on business operations. Because a root cause cannot be identified, your CTO asks you to help the network management team implement the FCAPS framework. On which two areas would you provide guidance to the network management team? (Choose two.)

You are designing a core MPLS-based network with a single OSPF area with no external routes. Which two mechanisms can be used to improve convergence time during a failure? (Choose two.)

An IBGP mesh design is being scoped, and in the discussions, one of the design engineers proposes the use of route reflectors. Which limitation is valid when using route reflectors in this "Pass Any Exam. Any Time." - www.actualtests.com 70 Cisco 352-001 Exam design?