Exam 44: Deploying Cisco Unified Contact Center Express

There are two hub-and-spoke networks in the following exhibit. Each has about 60 branches spread over a wide area. Connect routers P4S-RE and P4S-RF to two different frame providers. Problems with one provider have impacted branches connected to the other provider and reaching the data center. Which is the best place to build flooding domain boundaries to isolate these WAN issues?

Which major block is not included in the ETSI Network Function Virtualization reference framework?

You are designing a QoS solution for a large enterprise network that uses DMVPN. In which situation should the QoS pre-classify feature be used?

You are designing a network that will run EIGRP over a Metro Ethernet service that does not employ a link-loss technology. What will be the impact on convergence if there is a break in the end-to-end Layer 2 connectivity within the service provider network?

As part of the network design, ACME Corporation requires the ability to export IPv6 information to better manage its network. Which version of NetFlow records is required to export this information?

Your company requires two diverse multihop External Border Gateway Protocol peerings to a partner network. Which two methods would you use to improve lost peer detection? (Choose two.)

Your company is designing a service provider network management solution in which customers are billed for 95th percentile network utilization. The service provider requires that an IETF standard be utilized to collect the data. Which method should be used to collect the data?

You are a network administrator for the P4S Ltd. You are tasked to add a new OSPF router to an existing network. Later, you discover that two existing routers in the same area as the new router are using different MD5 keys to authenticate their neighbor relationships. Which option is correct if the new router is connected by means of a separate interface?

The Cisco MDS 9000 Series Multilayer SAN Switches can help lower the total cost of ownership of the most demanding storage environments. By combining a robust and flexible hardware architecture with multiple layers of network and storage-management intelligence, the Cisco MDS 9000 Series helps you build highly available, scalable storage networks with advanced security and unified management. What method does the Cisco MDS 9000 Series use to support trunking?

In a large enterprise network with multiple data centers and thousands of access devices, OSPF is becoming unstable due to link flapping. The current design has the access devices multihomed to large aggregation routers at each of the data centers. How would you redesign the network to improve stability?

Open Shortest Path First (OSPF) is a dynamic routing protocol for use in Internet Protocol (IP) networks. Study the exhibit carefully, OSPF is used as the PE-CE protocol at all of these sites. Which path is preferred from CE1 to CE3?

Which two items could be used to determine how much jitter is occurring across a customer's existing network? (Choose two.)

You have created a network design that has two point-to-point Metro Ethernet circuits extending a single production VLAN between two data centers. Under normal circumstances, one circuit will carry traffic and spanning tree will block the other. If the company wants you to make use of both circuits to carry production traffic, which two technologies and features will you investigate to integrate into your network design? (Choose two.)

A mobile network operator is designing an NGN backhaul and plans to migrate their legacy SDH and SONET-based transport network. The NGN network must achieve similar failover and failback times as the legacy network (50 milliseconds). Which method does allow for similar failover and failback times on the new packet-based network?

Which two aspects are considered when designing a dual hub, dual DMVPN cloud topology? (Choose two.)

In the network presented in the following exhibit, all routers are configured to perform EIGRP on all interfaces. All interface bandwidths are set to 1000, and the delays are configured as displayed. In the topology table at Router P4S-RC, you see only one path towards 10.1.1.0/24. Why Router P4S-RC only has one path in its topology table?

When designing a WAN that will be carrying real-time traffic, what are two important reasons to "Pass Any Exam. Any Time." - www.actualtests.com 56 Cisco 352-001 Exam consider serialization delay? (Choose two.)

Refer to the exhibit. Your company designed a network to allow server VLANs in a data center to span all access switches. In the design, Layer 3 VLAN interfaces and HSRP are configured on the aggregation switches. In which three ways should the design of the STP domain be optimized for server and application performance? (Choose three.)

Refer to the exhibit. The design is being proposed for use within the network. The CE devices are OSPF graceful restart- capable, and the core devices are OSPF graceful restart-aware. The WAN advertisements received from BGP are redistributed into OSPF. A forwarding supervisor failure event takes place on CE A. During this event, how will the routes learned from the WAN be seen on the core devices?

Your design client has requested that you ensure that the client devices are not dynamically configured with incorrect DNS information. When finalizing the network design, which security option must be configured on the switches?