Exam 44: Deploying Cisco Unified Contact Center Express

Refer to the exhibit. In this network design, where should summarization occur to provide the best summarization and optimal paths during a single-failure incident as well as during normal operation?

Your design plan includes mutual redistribution of two OSPF networks at multiple locations, with connectivity to all locations in both networks. How is this accomplished without creating routing loops?

In this BGP setup shown in the following exhibit, AS 400 advertises 10.1.1.0/24 to its peers. Border routers in AS 100 reset the next-hop router to themselves. P4S-R2, P4S-R3, and P4S-R4 are route reflector clients of P4S-R1 and P4S-R5 is a non-client iBGP peer of P4S-R1. Which option is the BGP next hop on P4S-R5 for the address 10.1.1.0/24?

Which two options are characteristics of DMVPN as related to IP multicast? (Choose two.)

A network designer has provisioned a router to use IPsec to encrypt the traffic over a GRE tunnel going to a web server at a remote location. From the router, the network designer can ping the web server, although the users in the office comment that they are unable to reach it. (Note: The DF bit is not set.) Which aspect should be changed in the design of the virtual connection?

What is one of the reasons that custom QoS ACLs are recommended over automatic QoS when configuring ports on a Catalyst 6500 for use with IP phones?

You are designing a network for a branch office. In order to improve convergence time, you are required to use the BFD feature. Which four routing protocols can you use to facilitate this? (Choose four.)

Tesla Radio GmbH is going to build a new research lab network based on a set of switches that would connect to their existing enterprise network. They are considering a design that would guarantee loop-free behavior within the set of switches. The design would also allow the group of switches to seem like a single switch to the enterprise network, because it is owned by a separate administrative group. Which Spanning Tree Protocol should be used to support the design requirements? "Pass Any Exam. Any Time." - www.actualtests.com 45 Cisco 352-001 Exam

You are a network engineer for the P4S Ltd. You are measuring one-way delay between two campus networks connected through an MPLS network. One campus is in Chicago and the other is in Dallas. The company has one appliance at each campus with which to measure the delay. Which of the following is a must for the two appliances in order for the engineer to measure one-way delay with the best possible accuracy?

A network designer is redesigning an enterprise campus network to ensure that Ethernet switches proactively attempt to reconnect after a fiber cut. In the design, they will have to address areas where fiber cuts exist on campus from past troubleshooting, where a single fiber is disconnected in the fiber pair, leading to looping. Which feature could be implemented in the design to allow the Spanning Tree Protocol on the switches to be protected? "Pass Any Exam. Any Time." - www.actualtests.com 4 Cisco 352-001 Exam

A financial services company runs HSRP at the edge of its network to allow for redundancy for the default gateway for its servers. The CTO of the company is concerned that the failover time for HSRP is too slow and a different mechanism should be used. The network engineer disagrees and believes that HSRP can provide the required fast down detection and failover for the edge of the network. Which option is the fastest down detection and failover solution for this HSRP environment?

Which is the reason that EIGRP uses queries?

Connecting an IS-IS router to four links and redistributing 75 routes from RIP. How many LSPs will be originated by this router?

A certain service provider network has IPsec tunnels between PE router loopbacks and dual-homed PE routers. The service provider carries infrastructure routes by use of OSPF and carries tunnel endpoints by using BGP. What should the service provider do to provide fast convergence in the event of a link failure in its network?

When designing fast convergence on a network using a loop-free alternate, on which two bases can the next-hop routes be precomputed? (Choose two.)

What should be taken into consideration when designing IPsec networks using Authentication Header (AH)?

Which of the following design options meet the requirement to provide IPv6 interdomain multicast?

A green data center is being deployed and a design requirement is to be able to readily scale server virtualization. Which IETF standard technology can provide this requirement?

When a design calls for spanning VLANs across a campus network, what are two issues that need to be addressed in the design? (Choose two.)

VLAN Tagging, also known as Frame Tagging, is a method developed by Cisco to help identify packets travelling through trunk links. When an Ethernet frame traverses a trunk link, a special VLAN tag is added to the frame and sent across the trunk link .How does ERS use the VLAN tag?